Watts Premier FILTER-PURE Spezifikationen PDF herunterladen (Seite 16)

Page 16

TROUBLE SHOOTING

Problem Cause Solution

1. Low/Slow Production Low Water Pressure Assure a minimum of 40 psi incoming water pressure.

Premier sells a booster pump if home water pressure is

low. Maker sure water supply is turned on and Adapta

Valve is all the way open

Crimps in tubing Check tubing and straighten or replace as necessary.

Clogged pre-ﬁ lters Replace pre-ﬁ lters.

Fouled membrane Replace membrane and ﬂ ow restrictor.

2. Milky colored Water Air in system Air in the system is a normal occurrence with initial

start up of the RO system. This milky look will

disappear during normal use within 1-2 weeks. If

condition reoccurs after ﬁ lter change, drain tank 1 to 2

times.

3. Water constantly Low water pressure See #1 Above

running unit will not

shut off Crimp in supply tube Check tubing and straighten or repair as necessary

4. Noise / Water from Crimp or restriction in Check tubing and straighten or repair as necessary.

faucet vent hole or noise drain line Straighten all drain lines. Clear blockage. Cut off any

from drain Excess tubing

Drain tube clogged Caused from dishwasher or garbage disposal.

Disconnect the 3/8” black line at the drain, clean the

3/8” black line out with a wire, then reconnect. Blowing

air through the line will not always remove the clog.

5. Small amount of water in System starting up Normally it takes 6-10 hours to ﬁ ll tank. Note: low

storage tank incoming water pressure and/or temperature can

drastically reduce production rate.

Low water pressure See #1 above.

To much air in tank Tank air pressure should be 5 psi when empty of water.

If below 5 psi add air or bleed if above 5 psi.

Check only when tank is empty of water.

See previous page.

6. Water leaks from the ﬁ lter / Not properly inserted Re-insert the ﬁ lter / membrane housing.

membrane housing

7. Low water ﬂ ow from faucet Check air in tank Use a Digital Air Gauge for best results. The empty

tank pressure should be 5-7 psi. To reset the air pressure

in the tank turn off water supply and drain tank by

opening faucet. When water stops ﬂ owing out of the

faucet. Remove schrader valve cover pump air into

tank until water stops ﬂ owing from the faucet. Release

the air out of the schrader valve until you reach 5-7 psi.

Replace schrader valve cover. Turn on Water.

Available From:

freshwatersystems.com

serving you since 1989

CLICK HERE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

Watts Premier FILTER-PURE Spezifikationen Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserspender Watts Premier FILTER-PURE