Watts Premier FILTER-PURE Spezifikationen PDF herunterladen (Seite 17)

Page 17

Watts Premier Inc.

1725 W. Williams Drive C-20

Phoenix, AZ 85027 USA

California Certiﬁ cation # 07-1882

RO-Pure

System conforms to NSF Standard 58 for speciﬁ c claims.

RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVALS:

Note: Depending on incoming feed water conditions replacement time frame may vary.

Description Change time Frame Cost

Sediment Pre-ﬁ lter: #105311 6 Months $12.50

Carbon Pre-ﬁ lter: #105351 6 Months $19.30

Final Carbon ﬁ lter #105361 12 Months $19.30

R.O. Membrane: #105331 2 to 5 years $72.95

This system has been tested according to NSF/ANSI 58 for reduction of the substances listed below. The concentration of the indicated substances in water

entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as speciﬁ ed in NSF/ANSI 58. This

system has been tested for the treatment of water containing pentavalent arsenic (also known as As (V), As (+5), or arsenate) at concentrations of 0.30 mg/L or

less. This system reduces pentavalent arsenic, but may not remove other forms of arsenic. This system is to be used on water supplies containing a detectable free

chlorine residual at the system inlet or on water supplies that have been demonstrated to contain only pentavalent arsenic. Treatment with chloramine (combined

chlorine) is not sufﬁ cient to ensure complete conversion of trivalent arsenic to pentavalent arsenic, Please see the Arsenic Facts section of the Performance Data

Sheet for further information.

Avg. In. Avg. Eff. % Reduction pH Pressure Max Eff. Inf. challenge Max Allowable

(mg/L) (mg/L) mg/L concentration concentration

mg/L mg/L

Arsenic (Pentavalent) .310 0.001 99.6% 7.24 50psi 0.002 0.30±10% 0.010 mg/L

Barium Reduction 9.2 0.08 99.0% 7.64 50psi 0.12 10.0±10% 2.0

Cadmium Reduction 0.031 0.0004 98.0% 7.49 50psi 0.0008 0.03±10% 0005

Chromium (Hexavalent) 0.30 0.002 99.0% 7.24 50psi 0.004 0.03±10% 0.1

Chromium (Trivalent) 0.30 0.001 99.0% 7.64 50psi 0.002 0.03±10% 0.1

Copper Reduction 3.2 0.02 99.0% 7.40 50psi 0.04 3.0±10% 1.3

Cysts 92,000#/ml 3 #/ml 99.99% 7.44 50psi 18 minimum 50,000/mL N/A

Fluoride Reduction 8.7 0.19 97.0% 7.24 50psi 0.3 8.0±10% 1.5

Lead Reduction 0.15 0.002 98.8% 7.39 50psi 0.005 0.15±10% 0.0107

Nitrate 27 3.8 86.0% 7.24 50psi 4.3 27.0 ±10% 10.0

Nitrite 3.1 0.41 86.0% 7.24 50psi 0.46 3.0 ±10% 1.0

Nitrate + Nitrite 30 4.2 86.0% 7.24 50psi 4.8 30.0 ±10% 10.0

Perchlorate 0.14 0.003 97.0% 7.39 50psi 0.005 mg/L 0.10±10% 0.006

Radium 226/228 25pCi/L 5pCi/L 80.0% 7.24 50psi 5pCi/L 25pCiL±10% 5pCiL

Selenium 94.85 <0.2 97.0% 7.24 50psi <0.2 0.10±10% 0.05

TDS 741 22 97.0% 7.28 50psi 26.0 750±40mg/L 187

Recovery - 15.77% Daily Production Rate - 18.43 GPD Efﬁ ciency - 8.82%

Depending on water chemistry, water temperature, and water pressure Watts Premier’s R.O. Systems production and performance will vary.

Efﬁ ciency rating means the percentage of the inﬂ uent water to the system that is available to the user as reverse osmosis treated water under

operating conditions that approximate typical daily usage. Recovery rating means the percentage of the inﬂ uent water to the membrane portion

of the system that is available to the user as reverse osmosis treated water when the system is operated without a storage tank or when the

storage tank is bypassed. There is an average of 4 gallons of reject water for every 1 gallon of product water produced.

REFER TO OWNER’S INSTALLATION/SERVICE MANUAL FOR FURTHER MAINTENANCE REQUIREMENTS AND WARRANTY

INFORMATION.

Phone: (623) 931-1977 Fax: (623) 931-0191 Email: [email protected]

GENERAL USE CONDITIONS:

1. System to be used with municipal or well water sources treated and tested on regular basis to insure bacteriological safe quality. DO NOT use with water that

is microbiologically unsafe or unknown quality without adequate disinfection before and after the system. Systems certiﬁ ed for cyst reduction may be used on

disinfected water that may contain ﬁ lterable cysts.

2. This system is acceptable for treatment of inﬂ uent concentrations of no more than 27 mg/L nitrate and 3 mg/L nitrite in combination measured as N and is

certiﬁ ed for nitrite/nitrate reduction only for water supplies with a pressure of 280 kPa (40 psig) or greater. If your water supply is under 40 psi Watts Premier

recomends the use of a RO booster pump for proper operation.

3. Operating Temperature: Maximum: 100°F (40.5°C) Minimum: 40° (4.4°)

4. Operating Water Pressure: Maximum: 85 psi (6.0kg/cm2) Minimum: 40 psi (2.8kg/cm2)

5. pH 2 to 11

6. No iron present in incoming feed water supply.

7. Hardness of more than 10 grains per gallon (170 ppm) may reduce RO membrane life expectancy.

8. Recommend TDS (Total Dissolved Solids) not to exceed 1800 ppm.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

Watts Premier FILTER-PURE Spezifikationen Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserspender Watts Premier FILTER-PURE